HVAC filtration of particles and trace metals: Airborne measurements and the evaluation of quantitative filter forensics.

Abstract

Filters installed in the heating, ventilation, and air-conditioning (HVAC) systems can serve as air-cleaning and sampling devices for indoor particles. The purpose of this article is to evaluate these dual roles. An occupied home with a central HVAC system equipped with a Minimum Efficiency Reporting Value (MERV, from ASHRAE Standard 52.2) 11 filter was monitored for six weeks. Weekly airborne gravimetric and real-time sampling was performed to measure the particle size distribution and the concentration of total suspended particles (TSP), PM10, PM2.5, PM1, and 12 trace metals. The weekly system runtimes were intentionally changed to provide a wide range of weekly filtration volumes. The quantitative filter forensics (QFF) concentrations of particulate matter (PM) and trace metals were calculated using the analysis of the dust collected on the HVAC filter, the filtration volume, and filter in-situ efficiency. The results indicated that filtration was not influential to remove PM and trace metals as the concentrations during the weeks with continuous HVAC operation were not consistently lower than those during the other weeks. This suggests the dominance of other particle and trace metal source and loss mechanisms weakens the influence of filtration in this home. The QFF evaluation results indicated that the concentration of TSP and over half of the tested trace metals (e.g., Pb, Cd, Ni, V, Sb, K, and Sr) could be estimated by QFF within a factor of two when compared to airborne sampling results. PM10, PM2.5, and PM1 concentrations were significantly underestimated by QFF potentially due to the limitations of size distribution analysis by a laser diffraction particle sizer (LDPS) for the detection of <1μm particles. Overall, while QFF was promising for TSP and some trace metals, improvement in size distribution analysis could extend the application of QFF for airborne sampling.