HPLC method for simultaneous determination of impurities and degradation products in Cardiazol

Abstract

Aim. The aim of study was to develop a simple and accurate procedure that could be applied for the determination of impurities and degradation products in cardiazol. Materials and methods. Separation in samples was carried out with Acquity H-class UPLC system (Waters, Milford, USA) equipped with Acquity UPLC BEH C18 column (2.1 × 50 mm, 1.7 μm) (Waters, Milford, USA). Xevo TQD triple quadrupole mass spectrometer detector (Waters Millford, USA) was used to obtain MS/MS data. Mobile phase A: 0.1% solution of trifluoroacetic acid R in water R; Mobile phase B: acetonitrile R. Samples were chromatographed in gradient mode (Table 1). Flow rate of the mobile phase: 1 ml / min. Column temperature: 30 °С. Detection: at 240 nm wavelength. Injection volume: 10 μl. Results. The retention time of the main substance is about 18.5 minutes. The order of the peak, the retention times and relative retention times: impurity B (12.04, 0.65); impurity А (18.5; 0.98); Cardiazol (18.87; 1.00). The LOD and LOQ values obtained were in the range of 30 ng/mL to 100 ng/mL and 80 ng/mL to 310 ng/mL respectively (with respect to sample concentration of 2 mg/ml). Linearity was established in the range of LOQ level to 0.2% having regression coefficients in the range of 0.9996 to 0.9999. The change in the temperature of the column affects the degree of separation of cardiazol and the impurity A, and thus, with a decrease of 5 ° C, the degree of separation is (1.06), while with increasing this index (3.43). When changing the flow rate of the mobile phase, the degree of separation changes in the following order, with a decrease to 0.9 ml / min separation (1.90), with an increase in speed to 1.1 ml / min (2.45). When the number of mobile phase B decreases by 5%, the degree of separation varies by (2.65), with an increase of 5% (1.82). In comparison with the chromatogram of the tested solution, the substance is not resistant to the action of peroxide, alkaline and acid decomposition. Conclusion. 1) HPLC method was developed and validated for the simultaneous detection and quantitation of impurities formed during the synthesis of cardiazol. 2) The method proved to be sensitive, selective, precise, linear, accurate and stability-indicating.