How can the failure mode and effect analysis improve the working processes in the ART center?

Abstract

Objective(s)Assisted reproductive technology (ART) Centers and laboratories perform complex tasks with patients and their gametes/embryos daily. The degree of problems/non-conformances in such surroundings must be minimized at zero point. This study aimed to establish the proper risk management system with well-defined process steps to prevent and eliminate problems/non-conformances. Study designFailure mode and effect analysis (FMEA) was introduced in the ART Center and the IVF laboratory. ART Center working processes were grouped into the categories of Clinical procedures, Forms, Identification, Personnel, Patients, and Facility. Working processes in the IVF laboratory were grouped into the categories of Consumables, Media, Equipment, Personnel, Working space, and Procedures. The traceability and safety of the working processes were evaluated before and after corrective measures regarding risk priority number (RPN). The severity (S), occurrence (O), and detection (D) index of problems/non-conformance were scaled from 1 to 5. The RPN was calculated by multiplying the SOD index, and the cut-off value for RPN was ≥12. ResultsThe increased RPN was found in the following working processes of the ART Center: Embryo transfer and pregnancy (RPN = 18) in the category of Clinical procedures; Informed consents and agreements (RPN = 16) in the category Forms; Continuous education of the knowledge and skills (RPN = 12) in Personnel category; Space conditions (RPN = 24) and Equipment (RPN = 12) in the category Facility.In the IVF laboratory, increased RPN was found in the following working processes: Production of the plasticware (RPN = 12), Transport (RPN = 12) and Storage (RPN = 12) in the category Consumables; Media production (RPN = 16) in category Media; Alarm notification system for the critical equipment (RPN = 12) in category Equipment; Personnel number and qualifications (RPN = 12), Standard operative procedures (SOP) (RPN = 12) and Continuous education of the knowledge and skills (RPN = 12) in category Personnel; Working conditions (RPN = 18) and Security (RPN = 20) in Working space; Patient identification (RPN = 20), Biological samples identification (RPN = 20), Records (RPN = 12), ART procedure (RPN = 30), Embryo transfer (RPN = 30) and Cryopreservation and thawing of biological samples (RPN = 30) in category Procedures.According to the RPN score, corrective measures were implemented. Most RPN scores were reduced after the implementation of the electronic witnessing system in patient/sample tracing steps. Phases Patient identification and Biological sample identification showed a double reduction of RPN scores, from 20 to 10. Also, for critical steps in ART procedures, Embryo transfer, Cryopreservation, and thawing of biological samples, the RPN score was reduced from 30 to 10. Proper education of personnel was another corrective measure that significantly contributed to a reduction of RPN scores in most of the categories. Conclusion(s)The FMEA analysis is useful in recognizing the critical steps of an ART Center. The RPN scores for patient traceability were successfully reduced using the electronic witnessing system. Nonetheless, the study has certain limitations, as FMEA is highly dependent on the specific healthcare organization, adherence to national guidelines, and the subjective nature of SOD and RPN evaluations.