Abstract
The influence of composition on the tendency for surface-crack propagation to occur on straightening of continuously cast strand of a commercial C–Mn–Nb–Al grade of steel has been examined and compared with the hot-ductility behaviour obtained from Gleeble tensile tests, using reduction of area as the measure for hot ductility. The tendency for surface-crack propagation was found to increase with Nb and soluble Al addition and to decrease with a rise in the P level. Hot ductility was also found to be affected in a similar manner by these elements. The results have been interpreted in terms of differences in the effectiveness of the NbCN precipitation in pinning the γ grain boundaries during deformation. From the close agreement between the hot-ductility behaviour as given by the Gleeble tests and the tendency for surface cracks to propagate during straightening of these steels at the exit from the continuous-casting machine, it has been concluded that the Gleeble test can be used with a fair degree of confidence to predict the behaviour on straightening of other steel compositions made by the continuous-casting process.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.