Abstract
The processes of finishing the surfaces of cylindrical and conical holes (including those up to 6 meters deep and up to 350 millimeters in diameter) are considered. These processes allow to obtain through holes with an accuracy of 6th grade with surface roughness Ra 0.32 microns) of special pipes, hydraulic cylinders, landing gear of aircraft and cylinders of internal combustion engines.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
