Year-end Sale % OFF 
Abstract
ABSTRACTThe homogenisation (Stage III) of austenite during non-equilibrium heating of hypereutectoid steels has been characterised for the first time through dilatometric strain measurements and electron microscopic techniques. It has been found that the homogenisation temperature (Ach) is significantly higher than the cementite dissolution temperature (Acm). Though there is a complete conversion of low-temperature constituents to austenite above the Acm, a significant segregation of carbon in the austenite is observed below the Ach. Performing heat treatment with an incomplete austenitisation between the Acm and the Ach temperature can affect the subsequent on-cooling phase transformations. It is proposed that the Ach temperature should be used as the full austenitisation temperature in hypereutectoid steels.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
