Abstract
Some present requirements of the mechanical structures are high strength and lightweight. A solution is to adopt the hollow structure design. In mechanical engineering industry are commonly using hollow structural sections, surface – type and even three dimensional hollow parts. The final shape is usually the result of structural optimization in which smallest material quantity fulfil the strength requirements. In this paper the study considers a different distribution of the same mass, more exactly starting with a single whole and “splitting” its surface in smaller and smaller holes each iteration. The intuitive expected result in reducing equivalent stresses considering von Mises criteria was not achieved.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.