Abstract
Hole-injection properties of annealed poly(alkoxy- and alkylthiophene) films in OLEDs were studied. Among them, annealed poly(3,3′-dihexyloxy-2,2′-bithiophene) (aPHOBT) film exhibited good hole-injection properties and a triple-layered OLED with the structure ITO/aPHOBT/PVK/Alq3/Mg–Ag (device I) showed much higher performance than a double-layered device without the aPHOBT layer (device II, ITO/PVK/Alq3/Mg–Ag). Device I was slightly inferior to a device having a PEDOT–PSS layer as the hole injector (device III, ITO/PEDOT– PSS/PVK/Alq3/Mg–Ag) in the low-intermediate region of the applied voltage (6–11 V), but gave comparable luminance to III when the applied voltage exceeded 11 V.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
