Histomorphometric evaluation of a dual acid-etched vs. a chemically modified hydrophilic dual acid-etched implant surface. An experimental study in dogs.

Abstract

The aim of this preclinical invivo study was to compare histologically and histomorphometrically osseointegration of dual acid-etched vs. hydrophilic implants. Two pairs of implants (Neodent, Curitiba, Brazil), with same macrogeometry but different surface technology (i) dual acid-etched surface (SAE) treatment with hydrochloric and sulfuric acid followed by microwave treatment and insertion in isotonic saline solution to increase hydrophilicity (SAE-HD) (test, n=12); (ii) dual SAE (control, n=12) were installed bilaterally in the proximal tibia of six beagle dogs. Histologic and histomorphometric evaluation was performed after 2 and 4weeks invivo, on non-decalcified sections. Percentages of bone-to-implant contact (BIC) and bone density (BD) were estimated and tested for significant differences with the Wilcoxon signed-rank test for paired samples (P<0.05). In general, new bone formation along and in contact with the implant surface could be observed irrespective of the experimental group and observation period. Most of the bone was woven but small quantities of lamellar bone, mainly in close proximity to the cortex could also be observed. BIC at 2weeks was 19.57±13.57 and 20.33±7.99 (P=0.75), and at 4weeks was 42.80±14.48 and 40.25±9.45 (P=0.65) for SAE-HD and SAE implants respectively. BD at 2weeks was 24.85±16.31 and 25.66±8.59 (P=0.35) and at 4weeks 44.13±6.46 and 40.13±6.46 (P=0.25) for SAE-HD and SAE implants respectively. Bone-to-implant contact and BD increased with time in both SAE-HD and SAE implants. No significant differences were observed between the two different implant surfaces for any of the evaluated parameters and at any observation time-point.