Abstract

BackgroundHyperspectral reflectance data in the visible, near infrared and shortwave infrared range (VIS–NIR–SWIR, 400–2500 nm) are commonly used to nondestructively measure plant leaf properties. We investigated the usefulness of VIS–NIR–SWIR as a high-throughput tool to measure six leaf properties of maize plants including chlorophyll content (CHL), leaf water content (LWC), specific leaf area (SLA), nitrogen (N), phosphorus (P), and potassium (K). This assessment was performed using the lines of the maize diversity panel. Data were collected from plants grown in greenhouse condition, as well as in the field under two nitrogen application regimes. Leaf-level hyperspectral data were collected with a VIS–NIR–SWIR spectroradiometer at tasseling. Two multivariate modeling approaches, partial least squares regression (PLSR) and support vector regression (SVR), were employed to estimate the leaf properties from hyperspectral data. Several common vegetation indices (VIs: GNDVI, RENDVI, and NDWI), which were calculated from hyperspectral data, were also assessed to estimate these leaf properties.ResultsSome VIs were able to estimate CHL and N (R2 > 0.68), but failed to estimate the other four leaf properties. Models developed with PLSR and SVR exhibited comparable performance to each other, and provided improved accuracy relative to VI models. CHL were estimated most successfully, with R2 (coefficient of determination) > 0.94 and ratio of performance to deviation (RPD) > 4.0. N was also predicted satisfactorily (R2 > 0.85 and RPD > 2.6). LWC, SLA and K were predicted moderately well, with R2 ranging from 0.54 to 0.70 and RPD from 1.5 to 1.8. The lowest prediction accuracy was for P, with R2 < 0.5 and RPD < 1.4.ConclusionThis study showed that VIS–NIR–SWIR reflectance spectroscopy is a promising tool for low-cost, nondestructive, and high-throughput analysis of a number of leaf physiological and biochemical properties. Full-spectrum based modeling approaches (PLSR and SVR) led to more accurate prediction models compared to VI-based methods. We called for the construction of a leaf VIS–NIR–SWIR spectral library that would greatly benefit the plant phenotyping community for the research of plant leaf traits.

Highlights

  • Hyperspectral reflectance data in the visible, near infrared and shortwave infrared range (VIS–NIR– SWIR, 400–2500 nm) are commonly used to nondestructively measure plant leaf properties

  • We evaluated the usefulness of VIS–NIR– SWIR hyperspectral data to estimate leaf physiological and chemical properties of maize plants from a maize diversity panel

  • In this study, we investigated the usefulness of VIS–NIR– SWIR leaf reflectance to estimate six leaf physiological and biochemical properties of maize plants

Read more

Summary

Introduction

Hyperspectral reflectance data in the visible, near infrared and shortwave infrared range (VIS–NIR– SWIR, 400–2500 nm) are commonly used to nondestructively measure plant leaf properties. We investigated the usefulness of VIS–NIR–SWIR as a high-throughput tool to measure six leaf properties of maize plants including chlorophyll content (CHL), leaf water content (LWC), specific leaf area (SLA), nitrogen (N), phosphorus (P), and potassium (K). This assessment was performed using the lines of the maize diversity panel. In the past few years, rapid advancements have been made in measuring morphological and structural traits of plants (height, size, leaf area, etc.) using imaging and image analysis [4, 5]. RGB (or visible light) cameras do not provide wide enough spectral ranges or high enough spectral resolution for chemical imaging, whereas hyperspectral imaging is still at its beginning stage for whole plant phenotyping, with a number of practical challenges yet to overcome [8]

Methods
Results
Discussion
Conclusion

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.