High-temperature deformation and failure of an orthorhombic titanium aluminide sheet material

Abstract

The high-temperature deformation and failure behavior of an orthorhombic titanium aluminide sheet alloy (fabricated by diffusion bonding of six thin foils) was established by conducting uniaxial tension and plane-strain compression tests at 980 °C and strain rates between 10−4 and 10−2 s−1. The stress-strain response was characterized by a peak stress at low strains followed by moderate flow softening. Values of the strain-rate sensitivity index (m) were between 0.10 and 0.32, and the plastic anisotropy parameter (R) was of the order of 0.6 to 1.0. Cavity nucleation and growth were observed during tensile deformation at strain rates of 10−3 s−1 and higher. However, the combined effects of lowm, low cavity growth rateη, and flow softening were deduced to be the source of failure controlled by necking and flow localization rather than cavitation-induced fracture prior to necking.