Abstract
A 1064-nm femtosecond fiber chirped pulse amplification (FCPA) laser system based on a single-stage double-pass Yb-doped rod-type photonic crystal fiber (PCF) amplifier was demonstrated with a pulse repetition rate of 500 kHz, which was specially designed for expected conversion efficiency enhancement of a 10.8 eV source. With a series of Yb:fiber power amplifiers, the average output power was boosted to approximately 35 W. Further, using a transmission gratings-based pulse compressor, an average output power of 27.5 W was achieved, corresponding to a pulse energy of 55 µJ and a compression efficiency of 78.6%. The shortest pulse duration was optimized to be 204 fs, which was also accompanied by obvious pedestal. A pulse duration of 336 fs was also obtained when the pulse quality was at a top priority. To the best of our knowledge, this is the first demonstration of high-repetition-rate high-pulse-energy 1064-nm, instead of 1035-nm, femtosecond laser, based on commercially available Yb-doped rod-type PCF amplifier.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.