High-power ultrasound bleaching technique for canola oil (Brassica napus L.): Pigments removal and quality parameters

Abstract

Canola seeds (Brassica napus L.) are among the most commonly used seeds in Mexico for vegetable oil production. This is based on the high yield and content of polyunsaturated and monounsaturated fatty acids. During oil bleaching, it is important to maintain fatty acids in their cis configuration because of the health concerns associated with trans-fatty acid consumption. In this sense, the industrial processing parameters employed for this purpose present some limitations, such as high temperatures and long times, which may change the cis configuration to trans. In addition, the amount of bleaching clay employed for this process could be a source of contamination because it is disposed of after treatment. Therefore, the aim of this study was to develop a bleaching process for canola oil using high-power ultrasound (US). US processing was applied to nine treatments with different processing times (60, 75, and 90 min), clay percentages (1, 2, and 3%), and temperatures (60 and 80 °C) to determine the concentrations of chlorophyll a and b (µg chlo/100 g oil), carotenes (µg β-carotene/100 g oil), color (L*, a*, b*, C*, and h°), iodine value (g I2/100 g oil), and finally carrying out a spectroscopic analysis (ATR-FTIR and Raman). A conventional bleaching treatment (100 °C for 180 min, 3% bleaching clay) was used as a control. The results revealed that US treatments with 2% clay at 60 °C for 60 and 90 min eliminated most of the chlorophyll compounds (98%). However, in terms of carotenes reduction, these identical treatments exhibited a similar tendency to that of the control (approximately 30% decrease). These findings also affected the sample color, in which US treatments revealed chromatic coordinates that indicated yellow tones with chroma values that were more intense than those in the control samples. In terms of the iodine value, such treatments fulfilled the international standards for vegetable oils (90–100 g I2/100 g oil). Finally, the spectroscopic study revealed no trans configurations or the presence of different chemical compounds after US treatment, because neither of them presented typical peaks for those molecular configurations. In this regard, US can be a useful methodology for bleaching vegetable oils, helping to reduce time, and bleaching clay with similar pigment reduction results.