Highly Selective and Fast Response/Recovery Cataluminescence Sensor Based on SnO2 for H2S Detection.

Abstract

In the present work, three kinds of nanosized SnO2 samples were successfully synthesized via a hydrothermal method with subsequent calcination at temperatures of 500 °C, 600 °C, and 700 °C. The morphology and structure of the as-prepared samples were characterized using X-ray diffraction, transmission electron microscopy, selected area electron diffraction, Brunauer-Emmett-Teller analysis, and X-ray photoelectron spectroscopy. The results clearly indicated that the SnO2 sample calcined at 600 °C had a higher amount of chemisorbed oxygen than the SnO2 samples calcined at 500 °C and 700 °C. Gas sensing investigations revealed that the cataluminescence (CTL) sensors based on the three SnO2 samples all exhibited high selectivity toward H2S, but the sensor based on SnO2-600 °C exhibited the highest response under the same conditions. At an operating temperature of 210 °C, the SnO2-600 °C sensor showed a good linear response to H2S in the concentration range of 20-420 ppm, with a detection limit of 8 ppm. The response and recovery times were 3.5 s/1.5 s for H2S gas within the linear range. The study on the sensing mechanism indicated that H2S was oxidized into excited states of SO2 by chemisorbed oxygen on the SnO2 surface, which was mainly responsible for CTL emission. The chemisorbed oxygen played an important role in the oxidation of H2S, and, as such, the reason for the SnO2-600 °C sensor showing the highest response could be ascribed to the highest amount of chemisorbed oxygen on its surface. The proposed SnO2-based gas sensor has great potential for the rapid monitoring of H2S.