Abstract
Anisotropic conductive film (ACF) has been used as interconnect material for flat-panel display module packages, such as liquid crystal displays (LCDs) in the technologies of tape automated bonding (TAB), chip-on-glass (COG), chip-on-film (COF), and chip-on-board (COB). Among them, COF is a relatively new technology after TAB and COG bonding, and its requirement for ACF becomes more stringent because of the need of high adhesion and fine-pitch interconnection. To meet these demands, strong interfacial adhesion between the ACF, substrate, and chip is a major issue. We have developed a multilayered ACF that has functional layers on both sides of a conventional ACF layer to improve the wetting properties of the resin on two-layer flex for better interface adhesion and to control the flow of conductive particles during thermocompression bonding and the resulting reliability of the interconnection using ACF. To investigate the enhancement of electrical properties and reliability of multilayered ACF in COF assemblies, we evaluated the performance in contact resistance and adhesion strength of a multilayered ACF and single-layered ACF under various environmental tests, such as a thermal cycling test (−55°C/+160°C, 1,000 cycles), a high-temperature humidity test (85°C/85% RH, 1,000 h), and a high-temperature storage test (150°C, 1,000 h). The contact resistance of the multilayered ACF joint was in an acceptable range of around a 10% increase of the initial value during the 85°C/85% RH test compared with the single-layered ACF because of the stronger moisture resistance of the multilayered ACF and flex substrate. The multilayered ACF has better adhesion properties compared with the conventional single-layered ACF during the 85°C/85% RH test because of the enhancement of the wetting to the surface of the polymide (PI) flex substrate with an adhesion-promoting nonconductive film (NCF) layer of multilayered ACF. The new ACF of the multilayered structure was successfully demonstrated in a fine-pitch COF module with a two-layer flex substrate.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.