Abstract
Applications of electrospinning (ES) range from fabrication of biomedical devices and tissue regeneration scaffolds to light manipulation and energy conversion, and even to deposition of materials that act as growth platforms for nanoscale catalysis. One major limitation to wide adoption of ES is stochastic fiber deposition resulting from the chaotic motion of the polymer stream as is approaches the deposition surface. In the past, fabrication of structures or materials with precisely determined mesoscale morphology has been accomplished through modification of electrode shape, use of multi-dimensional electrodes or pins, deposition onto weaving looms, hand-held electrospinning devices that allow the user to guide deposition, or electric field manipulation by lensing elements or apertures. In this work, we demonstrate an ES system that contains multiple high voltage power supplies that are independently controlled through a control algorithm implemented in LabVIEW. The end result is what we term “multiplex ES” where multiple independently controlled high-voltage signals are combined by the ES fiber to result in unique deposition control. COMSOL Multiphysics® software was used to model the electric field produced in this novel ES system. Using the multi-power supply system, we demonstrate fabrication of woven fiber materials that do not require complex deposition surfaces. Time-varied sinusoidal wave inputs were used to create electrospun torus shapes. The outer diameter of the tori was found, through parametric analysis, to be rather insensitive to frequency used during deposition, while inner diameter was inversely related to frequency, resulting in overall width of the tori increasing with frequency. Multiplex ES has a high-frequency cutoff based on the time response of the high voltage electrical circuit. These time constants were measured and minimized through the addition of parallel resistors that decreased impedance of the system and improved the high-frequency cutoff by up to 63%.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have