Abstract
A highly accurate measurement method of parameters of MZ-type LN optical intensity modulators is presented. In this method, a CW optical signal is input to an optical terminal and small CW RF signal is applied to an electrode of the modulator. Then sideband levels of an output optical signal at different bias points are measured by using optical spectrum analyzer. By using 1st order sideband levels which are measured at two different bias conditions, and using a compensation method to measured levels, we can obtain accurate chirp parameter even when very small power of RF signal is applied to the modulator. In this method, the chirp parameter can be obtained in good accuracy when the input RF voltage is only 3% of the halfwave voltage.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
