Abstract
Switching operations in gas insulated switchgear (GIS) can generate very fast transient overvoltages (VFTO) which propagate in the GIS with little attenuation. When a transformer is directly connected to the GIS through a gas/oil bushing, the VFTO can enter the transformer and excite the voltage oscillation in the windings. In the paper, we firstly show a resonance phenomenon due to the superposition of the traveling waves which was found in the experiments using the coil windings of a 500 kV transformer. The fundamental resonance frequency ranged at about 2 MHz, and its voltage at the interturn (turn-to-turn) of the coil could reach 0.25 times of the applied voltage in the worst case. Secondly, the electrical breakdown properties of interturn insulation in oil were studied, applying the unipolar and bipolar voltages with 2 MHz oscillatory frequency. The breakdown voltages at the unipolar and bipolar VFT oscillatory stresses were about 1.25 and 1.40 times higher than that at the standard lighting impulse, respectively. We discuss the experimental breakdown stresses with the ones estimated from the analysis of VFTO in the transformer windings and also show the methods to cope with the VFTO. © 2000 Scripta Technica, Electr Eng Jpn, 132(4): 45–52, 2000
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.