Abstract

AbstractDespite exceptionally high open‐circuit voltages, record high‐efficiency PERL (passivated emitter, rear locally diffused) silicon solar cells recently developed at the University of New South Wales demonstrate relatively low fill factors. This behaviour is shown to result from a surface recombination velocity at the rear Si‐SiO2 interface that increases with reducing voltage across the cell, leading to non‐ideal I‐V curves with high ideality factors (>1.3) near the maximum power point. When corrected for series resistance losses, the Air Mass 1.5 (AM1.5) fill factor of actual PERL cells is found to be limited to values below 82.9%, as opposed to the ideal theoretical limit of 85‐86% for silicon cells operating in low injection conditions. Relatively large series resistance losses (Rs > 0.35 ω cm2) further reduce this value to the experimentally observed fill factors below 81.4%.Analysis of measured illuminated and dark I‐V characteristics of PERL cells reveals that the AM1.5 efficiency is mainly limited by recombination losses at the rear oxidized surface. Optimum PERL cell resistivity is about 2 ω cm. Owing to increased rear surface recombination velocity, lower resistivity material shows no advantage in open‐circuit voltage and suffers from short‐circuit current losses, while a strong reduction in the surface recombination velocity above the maximum power point results in smaller fill factors. High‐resistivity cells do show an improved short‐cuircuit current but suffer from voltage and fill factor losses.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call