Abstract

We demonstrate the growth of InP nanowires on Si(111) using a thin InP buffer layer. The buffer layer is grown using a two-step procedure. The initial layer formation is ensured by using a very low growth temperature. An extremely high V/III ratio is necessary to prevent In droplet formation at this low temperature. The second layer is grown on the initial layer at a higher temperature and we find that post-growth annealing of the buffer layer does not improve its crystal quality significantly. It is found that the layers inherently have the (111)B polarity. Nanowires grown on this buffer layer have the same morphology and optical properties as nanowires grown on InP (111)B substrates. The vertical yield of the nanowires grown on the buffer layer is over 97% and we also find that crystal defects in the buffer layer do not affect the morphology, vertical yield or optical properties of the nanowires significantly.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.