High-throughput method for simultaneous quantification of N, C and S stable isotopes and contents in organics and soils.

Abstract

Information about the sulfur stable isotope composition (δ(34) S value) of organic materials and sediments, in addition to their nitrogen (δ(15) N value) and carbon (δ(13) C value) stable isotope compositions, can provide insights into mechanisms and processes in different areas of biological and geological research. The quantification of δ(34) S values has traditionally required an additional and often more difficult analytical procedure than NC dual analysis. Here, we report on the development of a high-throughput method that simultaneously measures the elemental and isotopic compositions of N, C and S in a single sample, and over a wide range of sample sizes and C/N and C/S ratios. We tested a commercially available CHNOS elemental analyzer in line with an isotope ratio mass spectrometer for the simultaneous quantification of N, C and S stable isotope ratios and contents, and modified the elemental analyzer in order to overcome the interference of (18) O in δ(34) S values, to minimize any water condensation that could also influence S memory, and to achieve the complete reduction of nitrogen oxides to N2 gas for accurate measurement of δ(15) N values. A selection of organic materials and soils was analyzed with a ratio of 1:1.4 standards to unknowns per run. The modifications allowed high quality measurements for N, C and S isotope ratios simultaneously (1 SD of ±0.13‰ for δ(15) N value, ±0.12‰ for δ(13) C value, and ±0.4‰ for δ(34) S value), with high throughput (>75 unknowns per run) and over a wide range of element amount per capsule (25 to 500μgN, 200-4000μg C, and 8-120μgS). This method is suitable for widespread use and can significantly enhance the application of δ(34) S measurements in a broad range of soils and organic samples in ecological and biogeochemical research. Copyright © 2016 John Wiley & Sons, Ltd.