Abstract
Flexible hydrogenated amorphous carbon (a-C:H) thin film coated on rubbers has shown outstanding protection of rubber seals from friction and wear. This work concentrates on the potential advances of expanding thermal plasma (ETP) process for a high throughput deposition of a-C:H thin films in Ar/C2H2 plasma on nitrile butadiene rubber (NBR). The effect of the arc current on the microstructure, interfacial adhesion and tribological properties of the deposited a-C:H films on NBR is scrutinized. The temperature variation during the short ETP process is small and only yields sub-millimeter segmented a-C:H films, in consistence with a previously developed model. Increasing the arc current from 30A to 75A leads to smaller sizes of film patches (reduced from 940μm to 125μm), enhanced adhesion strength from 20.4MPa to 91.8MPa and higher hardness (from 5.5GPa to 8.9GPa) of the deposited a-C:H films on rubber. The tribological performance of the ETP a-C:H coated NBR is a compromise between the adhesion strength and hardness of the a-C:H films, with the coefficient of friction being reduced from about 1 (uncoated NBR rubber) to less than 0.25 of a-C:H film coated NBR.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
