Abstract
The comparative investigation on the ablation transformations were carried out for the phenolformaldehyde resin composites on base of silica fabric and hollow corundum micro spheres. It was establish that the corundum micro spheres addition lead to the composite's heat conductivity reduction. As a result the temperature increased at the exposed spot, the linear erosion rate increased by the factor of 2,7 and the coking front line decreased by a factor of 2,3. In the issue the ablation gave rise to the high-temperature mechanical and chemical erosion and these last in turn triggered the number of the serial-parallel chemical reactions with both the composite material porosity increasing and the creation of the hightemperature reaction products mainly the silicon carbide.Ill.9. Ref. 9. Tab. 4.
Highlights
Волокнистые композиционные материалы на основе кремнеземного волокна и фенолоформальдегидной смолы могут быть использованы в изготовлении как высокотемпературных изделий специального назначения, так и изделий гражданского назначения [1,2,3]
A study on carbonization of phenolformaldehyde resin labelled with deuterium
― Hoboken, New Jersey : John Wiley & Sons, 2014
Summary
Для получения композиционных материалов были использованы фенолоформальдегидная смола марки СТН-150 производства ФКП «Алек-. Были использованы два типа композиционных материалов: композиты на основе кремнеземного волокна и фенолоформальдегидной смолы с корундовыми микросферами (STN-SM) и без корундовых микросфер (STN-S). Теплопроводность определяли методом лазерной вспышки на установке Netzsch LFA 457 MicroFlashTM в соответствии со стандартом ASTME-1461. Теромогравиметрические исследования проводили на установке Netzsch tg 209 F3 Tarsus. РФА проводили на установке Rigaku Ultima IV, Cu Kα (α = 1,5418, 0,5 град/мин). Для проведения абляционных испытаний использовали плазменную установку Multiplaz 3500: напряжение плазменного генератора (190±1) В, сила тока 9,5 A, расстояние между соплом и плоскостью испытуемого образца 20 мм, температура пламени на данном расстоянии около 2000 оC 2. Схема установки для абляционных испытаний: 1 ― плазменная горелка; 2 ― образец; 3 ― держатель; 4 ― пирометр; 5 ― компьютер
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.