Abstract
The strength, fatigue life and fracture behavior of the oxide dispersion strengthened (ODS) nickel-base superalloy PM 3030 are investigated. The high Al content in PM 3030 leads to the formation of coherent γ′ particles and, thus, to additional precipitation strengthening. A coarse and elongated grain structure (R34) and two isotropic batches with mean grain sizes of 1 μm (R90) and 17 μm (R901315) are considered. Compressive constant strain rate tests and high cycle fatigue (HCF) tests are performed. Optical, scanning and transmission electron microscopy (OM, SEM and TEM) are carried out. The properties are compared with those of the solely oxide dispersion strengthened Ni-base alloy PM 1000 [Estrin, Y., Heilmaier, M., Drew, G., 1999. Creep properties of an oxide dispersion strengthened nickel-base alloy: the effect of grain orientation and grain aspect ratio. Mater. Sci. Eng. A 272(1), 163–173]. It is found that additional γ′ hardening provides an increase in quasi-static strength by about a factor 2 and in HCF life by about a factor 10 2–10 3 at temperatures up to 850 °C. When fatigue life is compared at a fixed ratio of stress amplitude-to-yield or ultimate compressive strength, R34 shows a fatigue life similar to that of PM 1000 at lower temperature (e.g. 600 °C) indicating that the quasi-static strength advantage is proportionally translated into improved fatigue performance; for higher temperatures (850 °C) however, R34 shows a shorter fatigue life as compared to PM 1000. Grain size reduction, as exemplified with the fine grain R90 batch, also provides an increase in strength up to the equicohesion temperature ( T E) [Dieter, G.E., 1986. Mechanical Metallurgy. SI Metric ed. McGraw-Hill Book Company, London]. Above T E, faster diffusion and grain boundary sliding [Raj, R., Ashby, M.F., 1971. On the grain boundary sliding and diffusional creep. Metall. Trans. 2, 1113–1127; Spingarn, J.R., Nix, W.D., 1978. Diffusional creep and diffusionally accommodated grain rearrangement. Acta Metall. 26, 1389–1398] lead to a drastic drop in strength for the R90 material. In contrast, the batch with intermediate grain size (R901315) shows strength comparable to that of R34 up to 850 °C. Furthermore, R901315 shows improved crack tolerance compared to its coarse grain counterpart R34. Due to premature crack initiating coarse oxide particles however, R901315 does not show any improvement in elongation to failure during tensile tests. Eliminating those coarse particles is expected to improve the ductility and toughness of this isotropic batch.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
