Abstract
Roman metalworking crucibles are frequently characterized by an extra outer layer of clay, applied to a pre‐formed vessel. Three‐point bending and standardized dead‐weight loading tests were conducted to determine the advantages offered by the extra outer layer. Deformation and fracture behaviour, at temperatures up to 1100°C, of two‐layer, monolithic and tempered‐monolithic briquettes were compared. Measurements indicated that the two‐layer briquettes were more resistant to fracture at high temperatures: > 850°C they showed more extensive plastically deformed regions than monolithic briquettes. The influence of temper was consistent with previous results: tempering caused quasi‐stable fracture and reduced fracture strength. The results suggest extra outer layers assisted in preventing catastrophic failure.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.