High temperature mechanical properties of steel bars available in Pakistan

Abstract

PurposeThe purpose of this paper is to present the results of experimental testing of steel rebars at elevated temperatures. Three types of bars available in the local market in Pakistan were used. These data are not available in Pakistan.Design/methodology/approachThree types of bars were used, which included cold-twisted ribbed (CTR), hot-rolled deformed (HRD) and thermo-mechanically treated (TMT) bars. The diameter of the bar of each type was 16 mm. The bars were heated in an electrical furnace at temperatures which were varied from 100°C to 900°C in increment of 100°C. Bars of each type were also tested at ambient temperature as control specimens. The change of strength, strain and modulus of elasticity of the bars at high temperatures were determined.FindingsThe mechanical properties of the bars were nearly unaffected by the temperatures up to 200°C. CTR bars did not show yield plateau and strain hardening both at ambient and high temperatures. The high temperature yield strength and elastic modulus for all the three types of bars were similar at all temperatures. The yield plateau of both the HRD and TMT bars disappeared at temperatures greater than 300°C. The ultimate strength at high temperature of the HRD and TMT bars was also similar. The behaviours of the HRD and TMT bars changed to brittle beyond 400°C as compared to their behaviours at ambient temperature. The CTR bars exhibited ductile characteristics at failure at all the exposure temperatures relative to their behaviour at ambient temperature.Research limitations/implicationsThe parameters of the paper included the rebar type and heating temperature and the effects of temperature on strength and stiffness properties of the steel bars.Practical implicationsBuilding fire incidents have increased in Pakistan. As reinforced concrete (RC) buildings exist in the country in significant numbers, the data related to elevated temperature properties of steel is required. These data are not available in Pakistan presently. The presented paper aims at providing this information for the design engineers to enable them to assess and increase fire resistance of RC structural members.Originality/valueThe presented paper is unique in its nature in that there is no published contribution to date, to the best of authors’ knowledge, which has been carried out to assess the temperature-dependent mechanical properties of steel reinforcing bars available in Pakistan.