High Switching Performance of 1700V, 50A SiC Power MOSFET over Si IGBT/BiMOSFET for Advanced Power Conversion Applications

Abstract

Due to wider band gap of silicon carbide (SiC) compared to silicon (Si), MOSFET made in SiC has considerably lower drift region resistance, which is a significant resistive component in high-voltage power devices. With low on-state resistance and its inherently low switching loss, SiC MOSFETs can offer much improved efficiency and compact size for the converter compared to those using Si devices. In this paper, we report switching performance of a new 1700-V, 50-A SiC MOSFET designed and developed by Cree, Inc. Hard-switching losses of the SiC MOSFETs with different circuit parameters and operating conditions are measured and compared with the 1700-V Si BiMOSFET and 1700-V Si IGBT, using same test set-up. Based on switching and conduction losses, the operating boundary of output power and switching frequency of these devices are found out in a dc-dc boost converter and compared. The switching dv/dts and di/dts of SiC MOSFET are captured and discussed in the perspective of converter design. To validate the continuous operation, three dc-dc boost converters using these devices, are designed and tested at 10 kW of power with 1 kV of output voltage and 10 kHz of switching frequency. 1700V SiC Schottky diode is used as the blocking diode in each case. Corresponding converter efficiencies are evaluated and the junction temperature of each device is estimated. To demonstrate high switching frequency operation, the SiC MOSFET is switched upto 150 kHz within permissible junction temperature rise. A switch combination of the 1700-V SiC MOSFET and 1700-V SiC Schottky diode connected in series is also evaluated for zero voltage switching turn-ON behavior and compared with those of bipolar Si devices. Results show substantial power loss saving with the use of SiC MOSFET.