Abstract
Compression and tension split Hopkinson bar techniques are used to characterize high strength automotive sheet steels at strain rates of 500/s and 1000/s. Compression and tension data on two representative steel grades are given. There are differences in the measured compression and tension flow stresses for both the steels. The effect of strain rate and steel strength on these differences is discussed.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.