Abstract
Printing of electronics has been receiving increasing attention from academia and industry over the recent years. However, commonly used printing techniques have limited resolution of micro- or sub-microscale. Here, a directed-assembly-based printing technique, interfacial convective assembly, is reported, which utilizes a substrate-heating-induced solutal Marangoni convective flow to drive particles toward patterned substrates and then uses van der Waals interactions as well as geometrical confinement to trap the particles in the pattern areas. The influence of various assembly parameters including type of mixing solvent, substrate temperature, particle concentration, and assembly time is investigated. The results show successful assembly of various nanoparticles in patterns of different shapes with a high resolution down to 25 nm. In addition, the assembly only takes a few minutes, which is two orders of magnitude faster than conventional convective assembly. Small-sized (diameter below 5 nm) nanoparticles tend to coalesce during the assembly process and form sintered structures. The fabricated silver nanorods show single-crystal structure with a low resistivity of 8.58 × 10-5 Ω cm. With high versatility, high resolution, and high throughput, the interfacial convective assembly opens remarkable opportunities for printing next generation nanoelectronics and sensors.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
