High pressure salt water and low temperature effects on the material performance characteristics of additive manufacturing polymers

Abstract

The effects of salt water exposure at deep ocean depth pressures when coupled with low temperatures on the material characteristics of three unique additively manufactured polymers has been investigated through a detailed experimental approach. The polymers in the study were manufactured utilizing both Vat Photopolymerization and Material Extrusion printing techniques. The Material Extrusion process was utilized to produce material specimens of Stratasys ULTEM 9085 and Markforged Onyx while the Vat Photopolymerization process was used to produce specimens of Accura ClearVue. The ULTEM 9085 and Markforged Onyx are filament based polymers and the ClearVue is a liquid based resin. The specimens were first submerged in a high pressure, salt water bath of 3.5% NaCl solution at 34.5 MPa (5000 lb/in2) for a total exposure time of 60 days to determine the water absorption characteristics. Subsequent to the salt water exposure at high pressure, the specimens were evaluated to determine changes in tension, compression, flexure, and in-plane fracture properties. To determine the effects of water saturation and low temperature coupling, the mechanical testing was performed at temperatures of 20 °C, 0 °C and −20 °C in both dry and saturated conditions. Additionally, non-destructive testing in the form of TeraHertz and FIRT imaging was conducted to analyze the physical material changes through the thickness of the material due to the saline water absorption. To quantify the change in material storage and loss moduli properties, Dynamic Mechanical Analysis (DMA) characterization was performed on each of the AM polymers in dry and saturated states. The DMA testing also quantified changes in the Glass Transition Temperature because of salt water exposure. In summary, The current study investigates the effects of coupled long term/high pressure salt water exposure with low temperatures on the mechanical and material characteristics of three unique AM polymers by: (1) immersing the materials in a salt water solution at 34.5 MPa for 60 days, (2) Conducting post exposure mechanical testing on the materials at 0 °C and −20 °C with comparisons to 20 °C testing on dry specimens, and quantifies changes in material properties through DMA experiments. The results from all testing in the study show that high pressure salt water exposure when coupled with low temperatures has unique effects on each of the materials considered in the study and careful consideration to each parameter must be given based on the material type when components will be employed in marine operations.