High-pressure phase transitions and subduction behavior of continental crust at pressure–temperature conditions up to the upper part of the lower mantle

Abstract

We precisely determined detailed phase relations of upper continental crust (UCC) at 20–28GPa and 1200–1800°C across the 660-km discontinuity conditions with a high-pressure multi-anvil apparatus. We used multi-sample chambers packed with both of UCC and pressure marker, and they were kept simultaneously at the same high-pressure and high-temperature conditions in each run. The high-pressure experiments were carried out in pressure and temperature intervals of about 1GPa and 200°C, respectively. At 22–25GPa and 1600–1800°C, UCC transformed from the assemblage of CaAl4Si2O11-rich phase (CAS)+clinopyroxene+garnet+hollandite+stishovite to that of calcium ferrite+calcium perovskite+hollandite+stishovite via the assemblage of CAS+calcium ferrite+calcium perovskite+garnet+hollandite+stishovite. No CAS was observed at 1200°C. The textures and grain sizes in the run products suggested that hollandite (II) (monoclinic symmetry) was stable above 24–25GPa and transformed to hollandite (I) (tetragonal symmetry) during decompression. We calculated the density of UCC at high pressure and high temperature from the mineral proportions which were calculated from the mineral compositions. UCC has a higher density than PREM up to 23.5GPa in the range of 1200–1800°C. Above 24GPa, the density of UCC is lower than that of PREM at 1600–1800°C, but is almost equal to that at 1400°C and higher than PREM at temperature below 1400°C. Therefore, we suggest that the subducted UCC may penetrate the 660-km discontinuity into the lower mantle, when its temperature is lower than 1400°C at around 660km depth.