High‐Precision CTE Measurement of SiC‐100 for Cryogenic Space Telescopes

Abstract

ABSTRACTWe present the results of high‐precision measurements of the thermal expansion of sintered SiC, SiC‐100, intended for use in cryogenic space telescopes, in which minimization of thermal deformation of the mirror is critical, and precise information of the thermal expansion is needed for the telescope design. The temperature range of the measurements extends from room temperature down to ∼10 K. Three samples, Nos. 1, 2, and 3, were manufactured from blocks of SiC produced in different lots. The thermal expansion of the samples was measured with a cryogenic dilatometer, consisting of a laser interferometer, a cryostat, and a mechanical cooler. The typical thermal expansion curve is presented using an eighth‐order polynomial of the temperature. For the three samples, the coefficients of thermal expansion (CTE), α 1, α 2, and α 3, were derived for temperatures between 293 and 10 K. The average and the dispersion (1 σ rms) of these three CTEs are 0.816 × 10−6 and 0.002 × 10−6 K−1, respectively. No significant difference was detected in the CTE of the three samples from the different lots. Neither inhomogeneity nor anisotropy of the CTE was observed. Based on the CTE dispersion obtained, we performed a finite‐element method (FEM) analysis of the thermal deformation of a 3.5 m diameter cryogenic mirror made of six SiC‐100 segments. It was shown that the present CTE measurement has an accuracy that is sufficient for the design of the 3.5 m cryogenic infrared telescope mission SPICA (Space Infrared Telescope for Cosmology and Astrophysics).