Abstract
Low-temperature substrate sputtering on an acid-treated carbon nanotube (ATCNT) sheet result in high platinum (Pt) utilization. A thin catalyst layer (CL, ∼300 nm) with a high density of Pt and vacancies was formed on the ATCNT sheet (Pt-deposited ATCNT). It replaced the commercial carbon-supported Pt and microporous layers of the proton exchange membrane fuel cells. The substrate temperature (Tsub: 20, 5, −10, −30, and −50 ℃) contributed to crack formation in the porous Pt thin film and restrained the growth of Pt grain (average grain size from 8.60 to 3.97 nm). Below −10 ℃, the crack and grain size changed significantly. The increased crack and smaller grain size enlarged the Pt surface area while forming vacancies; this was confirmed via physical and electrochemical characterizations. When compared to Pt-deposited ATCNT (Tsub = 20 ℃, 47.61 m2 g-1Pt), the electrochemical surface area of Pt-deposited ATCNT (Tsub = -50 ℃, 72.06 m2 g-1Pt) increased by 51.35%. We present a high Pt mass-specific peak power density (5.93 kW g-1Pt), focusing on a strategy to increase Pt utilization.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
