Abstract

Novel SAW (surface acoustic wave) antenna-duplexers at 900 MHz and 1.684 GHz are presented. Each of the front ends consists of a transmitter path containing a SAW filter for noise suppression, a receiver path containing SAW filters and low-noise amplifiers, and a duplexing circuit. For the 900-MHz FDMA (frequency-division multiple access) mobile radio system the SAW filters must provide both filtering and diverging. The selectivity of the front end has been enhanced by a sophisticated design of the microstrip antenna terminal. For the European TDMA cordless telephone system, the SAW filters provide preselection and noise reduction, and pin-diode switching is used for time multiplexing. The transmitter path consists of three GaAs-FET low-noise driver amplifiers and the SAW filter. The selectivity of the receiver is enhanced by a stripline filter. The feasibility of the combination of SAW and microstrip technologies for the development of low-cost mobile radio units is demonstrated. Design, fabrication and performance of SAW microstrip front-ends in the low gigahertz range are reported. >

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.