Abstract
Abstract High performance miniature heat pipes are developed for the cooling of high heat flux electronics using new capillary structures made of a folded copper sheet fin. Using the folded sheet fin, capillary flow channels with fully and partially opened grooves are made by electric-discharge-machining technique. It is easy to form the capillary grooves as dense as desired through the present fabrication techniques. Heat pipes with two different capillary structures and different fill amounts are tested in the horizontal orientation. Three heating modes of the evaporator are simulated by activating different numbers of chip resistors. The heat pipe with partially opened groove wick performs better than that with fully opened groove wick. The condenser heat transfer coefficient is higher by 120% or greater in the case of the former wick type compared to the latter at an operating temperature of 110 °C. Heat fluxes higher than 140 W / cm 2 are achieved using concentrated heating modes.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
