Abstract
A high-performance fiber optic interferometric hydrophone based on a push-pull mandrel structure, with high sensitivity and wide-frequency response, is designed and developed. Each arm of the Michelson interferometer is a fiber coil wrapped onto a separate but concentric thin elastic tube as the sensing arm to detect acoustic pressure wave. The fiber optic hydrophone is fabricated and examined experimentally, demonstrating its capacity to detect very low-frequency underwater acoustic pressure variation. The theoretical design is validated experimentally, with results showing that the push-pull fiber optic hydrophone has an average sensitivity of -134.39 dB re rad/ μPa within the frequency range of 1 Hz-2 kHz, which is 5.67 dB higher than that of the analogous one-sensing-arm fiber optic interferometric mandrel hydrophone that we made for comparison. The push-pull fiber optic hydrophone has a minimum detectable pressure (MDP) of 25.37 μPa/√{Hz} at 1 kHz, about 15 dB lower than the deep-sea state zero (DSS0) level. At 10 Hz, the MDP is ~1.71 mPa/ √{Hz}, which is nearly 7 dB lower than the acoustic ambient noise in the ocean at low frequency. The sensitivity and the MDP of the push-pull fiber optic hydrophone have been doubled and improved by about 20% at 1 kHz, respectively, compared to other state-of-the-art flat response fiber optic hydrophones.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: IEEE Transactions on Instrumentation and Measurement
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.