High Mobility Amorphous Polymer‐Based 3D Stacked Pseudo Logic Circuits through Precision Printing

Abstract

AbstractDirect printing of conjugated polymer thin‐film transistors enables the fabrication of deformable devices with low cost, high throughput, and large area. However, a relatively poor device performance of printed devices remains a major obstacle to their application in high‐end display backplanes and integrated circuits. In this study, high‐performance and highly stackable printed organic transistors is developed, arrays, and circuits using a near‐amorphous polymer, indacenodithiophene‐co‐benzothiadiazole (IDT‐BT). The printed devices exhibited high saturation mobility (>1 cm2 V−1 s−1), high on/off ratio (>107), and low subthreshold slope (245 mV dec−1). In addition, 16 × 16 printed IDT‐BT arrays achieved 100% fabrication yield, with excellent device‐to‐device uniformity and low variations of mobility (9.55%) and threshold voltage (4.51%), and good operational and environmental stability (>365 days). Furthermore, five stacked 3D transistors are demonstrated with an excellent 3D uniformity without compromising device performance due to a low required thermal budget for processing amorphous IDT‐BT. Finally, a new concept of 3D universal logic gate with high voltage gain (33.91 V/V) and record density (100 printed transistors per cm2) is proposed and fabricated, which is relevant for the commercialization of low‐cost printed display backplanes and high‐density integrated circuits based on highly processable polymeric semiconductors.