High lift devices using compliant surfaces

Abstract

Stall delay and lift enhancement play a crucial role in modern aircraft performance. This is commonly achieved by devices such as slats or flaps located at the leading edge or trailing edge of an aircraft's wing. In this paper, we report a feasibility study of using light-weight compliant surfaces for novel high lift devices. The effects of compliant flags with one end fixed or both ends fixed near the leading edge and trailing edge of an airfoil were studied by force, flag deformation, and flow field measurements in a wind tunnel. When a flag is placed near the leading edge, the excitation of the separated shear layer from the leading edge is the main mechanism in increasing the lift at the post-stall angles of attack. In contrast, the trailing-edge flag with an excess length and both ends fixed could increase the effective camber and the circulation around the airfoil in a time-averaged sense. The mechanism is similar to that of the conventional Gurney flap effect, and equally effective at pre-stall and post-stall angles of attack. When used together, the compliant flags can delay stall angle by 8° and increase the maximum lift coefficient by 67% in the parameter range tested presently. Compliant surfaces require no external power as a passive method. If they are to be used as active methods, they are light weight, and can be stored and deployed easily.