Abstract

AbstractIn this work, the effectiveness of seven commercial compatibilizers is tested in polylactide (PLA)/poly(ε‐caprolactone) (PCL) blends with different compositions to obtain a high‐impact PLA. None of the compatibilizers is effective for 90/10 and 80/20 PLA/PCL compositions, as no improvement of the impact strength is observed. For the 70/30 composition, compatibilizers having glycidyl methacrylate (GMA) and acrylate groups in their structure are proved the most effective, as the morphological change towards co‐continuity induced by them leads to significant impact strength improvements (of ≈345% and 90% with respect to the neat PLA and the noncompatibilized PLA/PCL 70/30 blend, respectively). The 70/30 PLA/PCL composition, as it shows the best balance of properties, and the best compatibilizer (ElvaloyPTW) are chosen to carry out the optimization of the compatibilizer content. It is found that adding 6 phr to the blend results in highly toughened and ductile blends while maintaining a high modulus and yield strength values. Larger compatibilizer contents lead to even higher impact strength values, but the low‐strain mechanical properties are notably reduced. Thus, in this work, a simple and easily scalable method to produce high‐impact PLA is shown, as it implies the compounding of three commercially available components without involving any toxic solvents.

Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call