Abstract
A polarization-insensitive optical amplifier (PIOA) consisting of two serial semiconductor laser amplifiers (SLAs) is studied theoretically and experimentally. A polarization-insensitive isolator (PII) inserted between the two SLAs serves not only to eliminate the coupling cavity, but also to rotate any polarized forward light by 90 degrees . Experimental results show a maximum fiber-to-fiber gain of 29 dB. PIOA gain deviation for the input polarization launch angle is just 0.6 dB compared to an original value of 5-6 dB in a single SLA. A theoretical analysis shows that it is necessary to achieve a PII rotation design error of less than 0.5 degrees in order to suppress deviation below 0.1 dB. PIOA noise figure deviation, for the input signal polarization launch angle, was only 0.1 dB from both the experimental and theoretical results even though there was a rotation error of 2 degrees . >
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
