High fouling-resistance of polyamide desalination-membrane modified with PEI/PAH polyelectrolyte multilayers

Abstract

Membrane fouling is a persistent problem in reverse osmosis (RO) process which leads to higher operating pressure, quality deterioration, and frequent chemical cleaning of the membranes. The objective of this paper is to prepare a fouling-resistant RO desalination membrane while keeping high salt rejection and permeate flux. Polyamide (PA) membranes were prepared and modified using spin assisted Layer-by-Layer assembly of polyelectrolytes (PEI/PAH), characterized and tested in a cross-flow desalination setup. The effect of preparation conditions (number of coating layers, concentration and pH of the polyelectrolyte solutions) on the performance of the membrane was also investigated. SEM micrographs showed that the surface of the PA membrane is rough and has typical ridge and valley structure. However, images of the modified membranes showed smoother surfaces as the number of polyelectrolyte bilayers was increased which was verified using the AFM analysis. In addition, contact angle measurements suggested that the surfaces of the modified membranes became more hydrophilic due to the presence of hydrophilic hydroxyl and amine groups. Permeation results showed comparable salt rejection under saline feed water of 2000ppm. 50 bilayer modified membrane having 110mg/L of polyelectrolyte solution, possess permeability of 0.83L/m2hbar with 95% salt rejection. However, 27 bilayer modified membrane having 200mg/L of polyelectrolyte solution, possess greater permeability of 1.78L/m2hbar with 96% salt rejection. Fouling experiments showed that after three hours of filtration, functionalized membranes retained more than 88% of water flux compared to pristine polyamide membrane which suffered from more than 42% flux drop.