High-Entropy Composite Coating Based on AlCrFeCoNi as an Anode Material for Li-Ion Batteries

Abstract

In this study, a high entropy composite coating was synthesized by oxidizing a high entropy alloy, AlCrFeCoNi, at elevated temperatures in a pure oxygen atmosphere. X-Ray diffraction (XRD) analysis revealed that the prepared material was a dual-phase composite material consisting of a spinel-structured high entropy oxide and a metallic phase with a face-centered cubic structure. The metallic phase can improve the electrical conductivity of the oxide phase, resulting in improved electrochemical performance. Scanning electron microscopy with energy dispersive spectroscopy (SEM/EDS) analysis unveiled the compositional homogeneity of the composite material. The prepared material was utilized as an anode active material in lithium-ion batteries. Cyclic voltammetry (CV) revealed the oxidation and reduction regions, while the electrochemical impedance spectroscopy (EIS) measurements showed a decrease in the charge transfer resistance during the cycling process. A long-term rate capability test was conducted at various current densities: 100, 200, 500, 1000, and 2000 mA g−1. During this test, a notable phenomenon was observed in the regeneration process, where the capacity approached the initial discharge capacity. Remarkably, a high regeneration efficiency of 98% was achieved compared with the initial discharge capacity. This phenomenon is typically observed in composite nanomaterials. At a medium current density of 500 mA g−1, an incredible discharge capacity of 543 mAh g−1 was obtained after 1000 cycles. Based on the results, the prepared material shows great potential for use as an anode active material in lithium-ion batteries.