Abstract
In this work, the in-situ ZrB2/AA6111 composites with different particle volume fractions were prepared by direct melt reaction method and followed by hot extrusion deformation and T6 heat treatment. The microstructure characteristics, tensile and fatigue properties were carefully studied. The results showed that the addition of nano-ZrB2 particles made ZrB2/AA6111 composites have finer grains and the ultimate tensile strength of composites increases with the increase of particle volume fraction. The ZrB2/AA6111 composites showed higher fatigue limits than the unreinforced alloy, and the composites with a particle volume fraction of 2 vol% have the highest fatigue limit of 125 MPa, which is a 31.5% increase compared to the unreinforced alloy. Through microstructure analysis, it is found that the fatigue limit was related to the volume fraction and distribution of ZrB2 particles. The initial cracks of composite and unreinforced alloy were both caused by persistent slip bands and the crack propagation of the composites was more complex due to the resistance of reinforcing particles.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
