High Concentration Polymer Flooding is Successful

Abstract

Abstract Recently, new evidences show that the recovery factors of both partially hydrolyzed polyacrylamide (HPAM) and xanthan gum (XA) flooding increase with higher concentration and higher viscosity. However, when the incremental oil recovery of XA flooding in artificial cores reaches about 8.6% OOIP (original oil in place), the displacement efficiency of XA flooding levels of, but an incremental oil recovery of more than 20% OOIP can be obtained from HPAM flooding with a high concentration, the higher the concentration the higher the recovery, the recovery does not level of. The difference in recovery between the two solutions is due to the visco-elastic properties of HPAM. The visco-elastic property of HPAM fluid not only increases the volumetric sweep efficiency but also the displacement efficiency of the pay zone on a micro scale. A novel method has been developed to enhance the oil recovery in highly heterogeneous and high permeable reservoirs. The results on artificial cores with a Dykstra-Parson Coefficient of 0.72 show that an incremental recovery over water flooding of more than 20% OOIP can be obtained by early time injection of the high molecular weight, high concentration polymer solution, the earlier the better. The incremental recovery is comparable to surfactant flooding but at a lower cost. In Daqing Oil Field, a pilot test of high concentration polymer injectivity was conducted on 6 injection wells in August 2002. Three wells are injecting in high permeable pay zones and the other 3 wells in low permeable pay zones. The range of effective permeability (Keff) of the pay zones is 0.354 ~1.06 um2. The results show that high permeable formations (Keff>0.890um2) are suitable for continuous injection of high concentration polymer solutions (concentration 2,000 ppm ~2,500 ppm, molecular weight 17 million Daltons, viscosity 200~250 mPa.S). There were 22 oil wells around the 6 dispersive polymer injection wells. In February 2004, the average fluid production of each well was 90.2 tons per day, the average daily oil production of each well was 21.7 tons and average water cut was 79.5%. Compared to low concentration (1,000 ppm) solution flooding, the fluid production per day of each well remained and the daily oil production of each well increased by 3.4 tons (an increase of 18.6%) and the average water cut decreased by 1.0%.The average water cut decreased by a maximum of 7%.The results show that the injection of high concentration polymer fluid is very effective and the pilot area will be further expanded.