Abstract

In this study, ZnO, SnO2 and their composite (ZnO-SnO2) were synthesized by green route using aqueous extract of Solanum macrocarpon fruit and were used for the photo-reduction of hexavalent chromium. The synthetic route involved a two-step procedure, induced by temperature via calcination at 350 and 600 °C. The composite was prepared by the treatment of a mixture of the precursor compounds to a temperature up to 800 °C, and the extension of the temperature to 1000 °C, resulted in the emergence of ZnO-SnO2-Zn2SnO4 (ZTO). The nanoparticles were characterized by X-ray diffraction (XRD), transmission electron microscopy (TEM), and UV–vis spectroscopy. The XRD studies of the binary oxides confirmed a hexagonal wurtzite structure for the ZnO and a tetragonal phase SnO2, without any change in the diffraction patterns or supplementary diffraction peaks. The morphology of the nanoparticles indicated fairly spherical shapes for the ZnO, that tend to agglomerate with increase in temperature. The SnO2 showed rectangular shapes at both temperatures of reaction, while the ZnO-SnO2 composite showed the presence of both morphologies of the component binary oxides. In the photo-enhanced degradation study, under ultra-violet light, the effect of pH (2–8), concentration of chromium(VI) (2 – 8 ppm), and photocatalyst dosage (25 - 150 mg/L) on the reduction of Cr(VI) to Cr(III) were investigated. The reduction showed higher efficiency in acidic environment than in the alkaline environment, and also with increase in photocatalyst dosage. The composite exhibited the highest photoreduction efficiency, above 90%, at the optimum condition of pH 2, 150 mg/L photocatalyst, 2 ppm chromium solution after 90 min. These low-cost and nontoxic metal oxide and their green synthesized composite have great potentials for Cr(VI) pollution clean-up from waste water.

Highlights

  • Chromium based materials are receiving considerable attention for their numerous applications such as in green pigments, heterogeneous catalysis, coating materials for thermal protection, and wear resistance

  • The composite was prepared by the treatment of a mixture of the precursor compounds to a temperature up to 800 oC, and the extension of the temperature to 1000 oC, resulted in the emergence of Zinc oxide (ZnO)-SnO2-ZTO

  • The SnO2 showed rectangular shapes at both temperatures of reaction, while the ZnO-SnO2 composite showed the presence of both morphologies of the component binary oxides

Read more

Summary

Introduction

Chromium based materials are receiving considerable attention for their numerous applications such as in green pigments, heterogeneous catalysis, coating materials for thermal protection, and wear resistance. This is due to their excellent corrosion resistance, high hardness and good temperaturestability [1, 2]. Several techniques have been employed for the removal of Cr(VI) ion from wastewater Some of these methods include ion-exchange [7], electro reduction [8, 9], chemical reduction [10], biological reduction [11], and photocatalytic reduction [12]. The photocatalytic reduction of pollutants from wastewater has been widely applauded as an efficient, cost effective and sustainable technology [15]

Methods
Results
Conclusion
Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.