Heterogeneous Reactions of Gaseous HNO3 and NO2 on the Clay Minerals Kaolinite and Pyrophyllite

Abstract

Airborne clay mineral particles have long atmospheric lifetimes due to their relatively small size. To assess their impact on trace atmospheric gases, we investigated heterogeneous reactions on prototype clay minerals. Diffuse reflectance infrared spectroscopy identified surface-adsorbed products formed from the uptake of gaseous nitric acid and nitrogen dioxide on kaolinite and pyrophyllite. For kaolinite, a 1:1 phyllosilicate, HNO3 molecularly adsorbed onto the octahedral aluminum hydroxide and tetrahedral silicon oxide surfaces. Also detected on the aluminum hydroxide surface were irreversibly adsorbed monodentate, bidentate, bridged, and water-coordinated nitrate species as well as surface-adsorbed water. Similar adsorbed products formed during the uptake of NO2 on kaolinite at relative humidity (RH) of 0%, and the reaction was second order with respect to reactive surface sites and 1.5 +/- 0.1 for NO2. Reactive uptake coefficients, calculated using Brunauer, Emmett, and Teller surface areas, increased from (8.0 +/- 0.2) x 10(-8) to (2.3 +/- 0.4) x 10(-7) for NO2 concentrations ranging from 0.56 x 10(13) to 8.8 x 10(13) molecules cm(-3). UV-visible spectroscopy detected gaseous HONO as a product for the reaction of NO2 on wet kaolinite. The uptake of HNO3 on pyrophyllite, a 2:1 phyllosilicate, resulted in stronger signal for nitric acid molecularly adsorbed on the silicon oxide surface compared to kaolinite. Monodentate, bridged, and water-coordinated nitrate species bound to aluminum sites also formed during this reaction indicating that reactive sites on edge facets are important for this system. The uptake of NO2 on pyrophyllite, gammaBET = (7 +/- 1) x 10(-9), was significantly lower than kaolinite because NO2 did not react with the dominant tetrahedral silicon oxide surface. These results highlight general trends regarding the reactivity of tetrahedral silicon oxide and octahedral aluminum hydroxide clay surfaces and indicate that the heterogeneous chemistry of clay aerosols varies with mineralogy and cannot be predicted by elemental analysis.