Heterogeneous catalytic hydrogenation of canola oil using palladium

Abstract

AbstractThe hydrogenation of canola oil was studied using palladium black as a potential catalyst for producing partially hydrogenated fats with lowtrans‐isomer content. Pressure (150‐750 psig) appeared to have the largest effect ontrans‐isomer formation. At 750 psig, 90 C and 560 ppm metal concentration, a maximum of 18.7%trans isomers was obtained at IV 53. A nickel catalyst produces about 50%rans isomers at the same IV. For palladium black, the linolenate and linoleate selectivities were 1.2 and 2.7, respectively. The maximum level oftrans isomers observed ranged from 18.7% to 42.8% (150 psig). Temperature (30‐90 C) and catalyst concentration (80‐560 ppm) affected the reaction rate with little effect ontrans‐isomer formation and selectivities. At 250 psig and 50 C, supported palladium (5% Pd/C) appeared to be twice as active as palladium black. At 560 ppm Pd, 5% Pd/C produced 30.2%trans (IV 67.5), versus 19.0%trans for palladium black (IV 68.9). Respective linoleate selectivities were 15 and 6.6, while linolenate selectivities were approximately unity. Analysis of the oil samples by neutron activation showedapproximately a 1 ppm, Pdresidue after filtration.