Heavy metals distribution and risk assessment in soils affected by tannery effluents

Abstract

Effluents collected from tanneries in Sialkot showed considerably higher levels of heavy metals. Sodium (12 660.91 mg/L) among macronutrients and Cr (592.20 mg/L) among heavy metals were found in the highest concentrations. Effluent parameters, i.e. biological oxygen demand (BOD; 12.40), chemical oxygen demand (COD; 16.53), Cd (5.90), Cr (592.20) and Fe (18.59) were the respective times higher than Pakistan National Environmental Quality Standards and their continuous unchecked discharge into agricultural soils poses a potential risk. Mean concentrations (mg/L) of Cr (592.20), Ni (2.66), Mn (1.16), Fe (37.17), Zn (0.90), Cd (0.59) and Pb (1.18) in this study exceeded levels recorded to date from different tanning hubs in Pakistan. Factor analysis/principal components analysis (FA/PCA) for the effluent parameters resulted in six varimax factors, i.e. VF1 (salinity, electrical conductivity, total dissolved solids, chloride, phosphate, BOD and COD; including characteristic tannery effluent features), VF2 (pH, Cr and alkalinity; tanning operations), VF3 (Cd and Pb; dyeing processes), VF4 (Mn and Fe; finishing operations), VF5 (Ni; retaining processes) and VF6 (hardness, Ca and Cu; bating processes). Cluster analysis performed on metal data resulted in three clusters confirming metal–metal relations obtained either from FA/PCA or a correlation matrix. The results of this study are useful for heavy metal source apportionment, assessment of risk to peripheral soils and the future management of environments around tanneries.