Heavy metal and volatile organic chemical removal and treatment in on-site wastewater infiltration systems

Abstract

Solvents, greases, and rinse waters from routine vehicle maintenance contain heavy metals and volatile organic chemicals (VOCs). In Wisconsin, these fluids enter catch basins along with rinsing waters and are discharged to soil infiltration systems drainfields after mixing with domestic wastewaters in a septic tank. The purpose of this study was to monitor heavy metal and VOC removal and treatment in catch basins and septic tanks at four publicly-owned motor vehicle service stations (MVSS). Cadmium, chromium, and lead were found in catch basin wastewater, septic tank effluent, and septic tank sludge at concentrations ranging from 0.002–7.7 mg L−1. Lead was found in the highest concentration. The highest concentrations of metals were in septic tank sludge. Of the >50 VOCs scanned for in catch basin wastewater, septic tank effluent, and septic tank sludge samples, 29 were found in concentrations that exceeded analytical detection limits. Concentrations of detected VOCs ranged from 1.0–15,800 µg L−1 and the highest concentrations of VOCs were found in catch basin wastewater and septic tank sludge. Acetone, ethylbenzene, toluene, and xylenes were the most commonly found VOCs at all sampling locations. Thus, heavy metals and VOCs were not completely removed in catch basins and were discharged to septic tanks where removal occured possibly as these contaminants settled with solids in the sludge. The level of treatment was, however, inadequate and heavy metals and VOCs were discharged to drainfields.