Abstract
Flash spray cooling has been subject to increased attention because of its high heat dissipation capacity at low surface temperature in the application of high power technologies. In this study, experiment was conducted to study the effects of spray distance and nozzle diameter on heat transfer performance in a closed-loop R410A flash spray cooling system for the first time. Five spray distance from 10 mm to 30 mm and three nozzles with same internal structure but different diameters of 0.51, 0.56 and 0.69 mm were employed. The experiment results indicated the critical heat flux (CHF) value firstly increased and then deceased with the increase of spray distance, which is consistent with previous research of spray cooling with FC-72 and FC-87. The highest CHF value reached 264 W/cm2 while maintaining surface temperature below 30 °C and heat transfer coefficient (HTC) was about 210 kW/(m2·K) at 25 mm, which were 60% higher than those at 10 mm spray distance. The nozzle with medium orifice diameter of 0.56 mm showed a superior cooling performance, instead of larger nozzle with higher refrigerant flow rate. Therefore, there existed a counterbalance between the mass flow and outlet velocity in determining the optimum nozzle orifice diameter.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
